1. Homework preparation

(1) Prepare various production tools and check whether there are bolts protruding from each guide plate.

(2) Confirm that the buttons on the console are at zero position and there are no obstacles around the equipment.

(3) Close the switch of the electric control cabinet, start each DC power supply and pumping station, and connect the air source.

2. Scissors adjustment

Knife unloading: remove the archway, open the operating side frame, then loosen and remove the nuts of the upper and lower shafts with a hook wrench, and put on the wire guard. Remove the pressure knife ring, remove the blade, and finally wipe the knife shaft clean with a rag.

Knife installation: In the process of installing the knife and the isolation sleeve, the knife must be cleaned with a rag before the knife is installed, and the scissors are installed first.

3. Production preparation

Uncoiler: The rewinding trolley returns to the saddle - the front movable support swings down to the lower limit - the diameter of the uncoiler drum shrinks, the pressure roller is lifted to the upper limit - the front looper plate is lifted.

Main control worker: open the guide roller to the maximum limit - swing the front guide plate - lift the guide plate to the upper limit by the rear looper - replace the spacer ring according to the width of the cut strip.

Coiler: replace the carpet of the tension table—adjust the hydraulic pressure of the main tension table and the air pressure of the secondary tension table according to the thickness of the strip steel—start the centering station—raise the rear guide plate—shrink the diameter of the coiler drum, and return the push plate to At the rear limit, the pressure roller is lifted to the upper limit—the rear movable support pendulum is lowered to the lower limit—the coil unloading trolley returns to the operating side—the pinch roller is lifted.

4. Wear belt

Uncoiler: hoist the produced coil to the saddle—put the strip on the center line of the uncoiler—support the front movable support, lower the trolley, expand the diameter of the reel, and press down the pressure roller—pass the strip manually Go to the power guide roller - centering, so that the cutting edge can cut the guiding edge - after the strip steel passes through the disc shear, the looper guide plate is put down, and the sleeve is punched.

Main control worker: Jog the uncoiler forward and disc shears to make the strip steel reach the tension table—jog to make the strip steel pass through the hydraulic shears and press down the pressure roller—cooperate with the coiler to pass the strip steel to the coiler and Diameter expansion—put down the front guide plate and the rear looper guide plate, and punch the looper backward.

Coiler: When the main control worker sends the strip steel to the pinch roller, press down the pinch roller to clamp the strip steel—with the cooperation of the main control worker, send the strip head into the jaw of the coiler and expand the diameter— The rear guide plate is put down, and the rear movable support is put up—turn the centering system to automatic centering—press down the pressure roller of the tension table—the coiler wraps the steel coil 3 to 5 times, and press down the tension table and main force table The pinch rollers are raised.

5. Waste collection

Thread the waste edge wire to the edge material collector, and then start the edge material collector to collect the waste.

We Are Slitting line Manufacturer

BANGZHOU Machinery is a slitting line manufacturer that specializes in the production of high quality machines. Our machines are used in a variety of industries, including the metal and aluminum sheet industry. We have a team of experienced engineers who are dedicated to create machines that are durable and easy to operate. We also have a team of customer service representatives who are available to answer any questions you may have about our products.